[fa icon="calendar"] Jul 4, 2016 9:23:00 AM / by Craig Paullin   



They gave us this:

Make us a high tolerance part for the cellular phone industry that will be used in a very demanding service environment. Its purpose is to dissipate heat from the main computer chip in antenna booster stations that drive the cellular network.


We did this:

PSM knew that aluminum die castings had been attempted, but lacked the thermal conductivity to be an effective heat remover. PSM also knew the part had been machined from high conductivity copper, but the cost was prohibitive. Using the power of powdered metal technology, PSM created a repeatable high tolerance part from a high conductivity material. The part is less than 10% of the cost of machining from bar stock with no waste.


We got this:

New P/M heat sink met or exceeded all expectations and is now in use worldwide. There are no field failures. And the part won PSM the prestigious MPIF P/M Design Competition in the Nonferrous Category for 1999.


Do you have a challenging project that needs a solution? 

Send Us Your Challenge!


Topics: Case Studies

Craig Paullin

Written by Craig Paullin

President of PSM Industries

澳洲幸运10开奖预测 澳洲5精准计划 极速赛车官方直播 澳洲10开奖软件下载 SG赛车在线走势图